Hunter PGJ Popup 100mm Adjustable Arc Pressure Rating: 6.9 Bar, 100 PSI
(Recommended pressure range 30 to 50 PSI)
Radius: 4.3m to 11.6m
Connection Type: Female NPT thread Features
Pressure Rating: 6.9 Bar, 100 PSI(Recommended pressure range 30 to 50 PSI)Radius: 4.3m to 11.6mConnection Type: Female NPT thread
The Hunter PGJ is a small residential rotor pop-up sprinkler
Radius 4.3m to 11.6m
Height 100mm (4 inch)
Arc adjustable from 40 degrees to 360 degrees
The PGJ was built to bring all the efficient benefits of rotary sprinklers to applications that typically call for a spray. The PGJ can work in tandem with larger rotors to combine big and small areas in a single zone, offering convenience and efficiency that sprays do not. When used in the right application, the PGJ allows fewer heads to perform more efficiently at a more economical price.
Advanced Features
Headed and slotted setscrew allows radius adjustment with a Hunter wrench or flat blade screwdriver
Standard factory-installed 2.0 nozzle speeds installation
Quickcheck arc mechanism for fast arc adjustment
Hunter Key is required to make any adjustments to sprinkler (Product Code “HK”)
Tips
Arc Adjustments: Adjustable heads are preset to 180 degrees. Sprinklers may be adjusted with water on or off. It is recommended that initial adjustments be made before installation.
Using the palm of your hand, rotate the nozzle turret counter clockwise to the left stop to complete any interrupted rotation cycle
Rotate the nozzle turret clockwise to the right stop. This is the fixed side of the arc. The nozzle turret must be held in this position for arc adjustments. The right stop does not change
To increase the arc
Insert the plastic key end of the Hunter wrench into the adjustment socket (hole with + – symbols)
While holding the nozzle turret at the right stop, turn the wrench clockwise. Each full 360 ̊ turn of the wrench will increase the arc 90 ̊.
Adjust to any arc between 40 ̊ and 360 ̊
The wrench will stop turning, or there will be a ratcheting noise, when the maximum arc of 360 ̊ (full circle) has been reached
To decrease the arc
Insert the plastic key end of the Hunter wrench into the adjustment socket (hole with + – symbols)
While holding the nozzle turret at the right stop, turn the wrench counter-clockwise. Each full 360 ̊ turn of the wrench will decrease the arc 90 ̊.
Adjust to any arc between 40 ̊ and 360 ̊
The wrench will stop turning, or there will be a ratcheting noise, when the minimum arc of 40 ̊ has been reached
Refer YouTube installation videos
