Hunter Key Features
Hunter rotor adjustment key
Tips
Arc Adjustments: Adjustable heads are preset to 180 degrees. Sprinklers may be adjusted with water on or off. It is recommended that initial adjustments be made before installation.
Using the palm of your hand, rotate the nozzle turret counter clockwise to the left stop to complete any interrupted rotation cycle
Rotate the nozzle turret clockwise to the right stop. This is the fixed side of the arc. The nozzle turret must be held in this position for arc adjustments. The right stop does not change
To increase the arc
Insert the plastic key end of the Hunter wrench into the adjustment socket (hole with + – symbols)
While holding the nozzle turret at the right stop, turn the wrench clockwise. Each full 360 ÌŠ turn of the wrench will increase the arc 90 ÌŠ.
Adjust to any arc between 40 ÌŠ and 360 ÌŠ
The wrench will stop turning, or there will be a ratcheting noise, when the maximum arc of 360 ÌŠ (full circle) has been reached
To decrease the arc
Insert the plastic key end of the Hunter wrench into the adjustment socket (hole with + – symbols)
While holding the nozzle turret at the right stop, turn the wrench counter-clockwise. Each full 360 ÌŠ turn of the wrench will decrease the arc 90 ÌŠ.
Adjust to any arc between 40 ÌŠ and 360 ÌŠ
The wrench will stop turning, or there will be a ratcheting noise, when the minimum arc of 40 ÌŠ has been reached
Refer YouTube installation videos
